DHCP Server on Mikrotik RB133 AP we used to share Internet access with wireless media Lan (wlan).
There have been many who discuss this matter, but it never hurts if I try to share my experience of direct practice instructions on another blog that was not 100 percent running, and after I try it again then there are some settings which I will explain as follows:
As I tried was peratalan RB133 with specifications:
3 = ether1 ether card, ether2, and ether3 plus one wlan1
if we show from Winbox v2.9.46 tanpilan appear as follows:
There have been many who discuss this matter, but it never hurts if I try to share my experience of direct practice instructions on another blog that was not 100 percent running, and after I try it again then there are some settings which I will explain as follows:
As I tried was peratalan RB133 with specifications:
3 = ether1 ether card, ether2, and ether3 plus one wlan1
if we show from Winbox v2.9.46 tanpilan appear as follows:
With IP configuration as follows:
IP->Addresses-> [+]
IP->Addresses->[+]
IP->Addresses->[+]
Add the DNS Server :[Admin @ MikroTik ] > ip dns set primary - dns = 192.168.1.1 allow- remote -requests = no[Admin @ MikroTik ] > ip dns set secondary - dns = 202.134.1.10 allow- remote -requests = noAdd Speedy Modem Gateway to :[ admin @ MikroTik ] > ip route add gateway = 192.168.1.1Ping the gateway to do the following :[ admin @ MikroTik ] > ping 192.168.1.1192.168.1.1 64 byte ping : ttl = 64 time = 3 ms192.168.1.1 64 byte ping : ttl = 64 time = 3 ms192.168.1.1 64 byte ping : ttl = 64 time = 3 msIf successful will come out as above .To ascertain what dns also gone the way of doing a ping to google.com[ admin @ MikroTik ] > ping google.com64.233.187.99 64 byte ping : ttl = 237 time = 315 ms64.233.187.99 64 byte ping : ttl = 237 time = 315 ms64.233.187.99 64 byte ping : ttl = 237 time = 314 msff . means already tesambung to the Internet .Add Pool on Mikrotik terminal[Admin @ MikroTik ] > ip pool add name = pool1 ranges = 192.168.3.10-192.168.3.100Add a DHCP server :[Admin @ MikroTik ] > ip dhcp - server add name = server1 address - pool = pool1 interface = wlan1Perform NAT with action = masquerade :[Admin @ MikroTik ] > ip firewall nat add action = masquerade out - interface = ether1 chain = srcnatNow prepare Notebook wlan enabled DHCP IP sets , and try to activate .If there already is an IP 192.168.3.100 DHCP already terbroadcast mean , try browsing google.comIf you've can mean all the work we've been successful .If there is no signal then activate Wlan Wireless AP Bridge mode .
Tidak ada komentar:
Posting Komentar